Cleaning and lubricating my Teletype ASR 33


Since the ASR 33 had been sitting in Tom’s basement for a few years I disassembled, cleaned and lubricated the Teletype before doing any testing.

 

Below is a syringe I used to put very small drops of oil at the designated lubrication points. The syringe is made from plastic and I made the tip a lot smaller the following way:

  1. Put a screw into it’s to large tip.
  2. Held the screw by my finger tips.
  3. Carefully heated the tip using a gas fired, portable soldering iron with the torch tip attached and let the syringe slowly descend downwards and thereby stretching the tip making it much smaller.

  1. No comments yet.
(will not be published)
*


Page optimized by WP Minify WordPress Plugin