Posts Tagged Data General
My Nova 3’s 128kW Plessey Memory Board has another bit error – bit 7
Posted by Tommie in The Data General Nova 3 Restoration Project on Sunday 25 April, 2010
The Nova’s memory error indicates a flaky signal, but which signal? The error manifests itself on address 40000(oct), bit 7, but only running MEMDIAGLONG.ASM. Running MEMDIAGSHORT.ASM and MEMADDRTEST.ASM on the full 32kW works fine. MEMDIAGLONG runs fine up to the 16k boundary which would imply a faulty memory chip with a pattern sensitive problem, but manually loading memory generates a parity error in any location for bit 7, including the first 16k, which would indicate a faulty bus latch.
(MEMDIAGSHORT.ASM, MEMADDRTEST.ASM and MEMDIAGLONG.ASM are diagnostics by of 11/27/79 by T.P. Povlick that are loaded using the front panel switches.)
Nova 3 Plessey 128kW Memory Board with IC U146 16kx1 memory MK4116N-4 removed
The bit 7, address 40000 – 77777 (oct) error is now fixed by replacing the chip at row 2, column 7; IC U146. The 16kx1 memory IC is a MK4116N-4. (The Plessey board is 128kW consisting of 8 rows and 16 columns of 16kx1 chips.) Running MEMDIAGLONG.ASM on the full 32k now works fine. Since I currently have no floppy, disk or tape drive attached to the CPU, I am unable to run diagnostics on the full 128kW (256kB) address range.
I started the memory testing program MEMDIAGLONG at 13:50. The program runs 10 minutes per 1k of memory and was finished at 19:10 with no errors. Time running = 5h20m.
The Nova 3/12 Console is repaired
Posted by Tommie in Data General Minicomputer Projects, The Data General Nova 3 Restoration Project on Wednesday 24 February, 2010
The ”Stop/Reset” toggle switch wouldn’t toggle back to its center position so I took a switch from my other Nova 3 console. Turns out that this switch would not make contact in the “Stop” position and I had to grab yet another switch from my other front panel. Looks as this front panel rapidly is becoming an assembly to salvage parts from.
All indicator lights are now replaced. The leads of the ones that did work where extremely brittle and since incandescent lamps have limited lifetime I decided to replace all lamps. Lights 7 – 12 would not lit or if they did, they lit very dimly and sporadic. The driver chip, DG part # 113-7748 was faulty and I replaced it with a NTE74LS06 chip (Hex Inverter Buffers/Drivers With Open-Collector High-Voltage Outputs).
Now that the console is working (apart from lacking the XX2065 key which I have ordered), I can start testing the cpu and memory.
Nova 3 Console disassembled
Nova 3 Console Lamp Driver DG part 113-7748
Nova 3 Console Lights works fine after replacing all lamps and a driver IC
Powered up my Nova 3/12 today
Posted by Tommie in Data General Minicomputer Projects, The Data General Nova 3 Restoration Project on Sunday 14 February, 2010
After sitting in my hallway for 3 months now, I finally got around to do some work on my Nova 3/12. The installed power supply was faulty. 5 VDC worked fine while all voltages based on the raw 15 VDC was missing. I did some trouble shooting but decided to use the power supply from my other Nova 3/12 chassis. This power supply worked fine after replacing the 5VDC and 15VDC capacitors on the Power Supply board and adjusting the 5VDC and the 15VDC voltage levels.
With only the front panel installed I applied power to the chassis and a plume of smoke rose from the front panel logic board and the typical smell of burnt electronics spread throughout my apartment. I quickly pulled the power plug and disassembled to front panel. One of the decoupling capacitors on the 15VDC power bus had its plastic coating melted and of the internals only a black crust remained. Not unusual for old capacitors to develop a short. I decided to use the front panel from my empty Nova 3/12 chassis and voila – the light bulbs that were not broken came on.
I’ve ordered 30 sets of 28V .04A Hudson 2187D equivalent lamp bulbs and a fan that needs replacing.
Data General Nova 3/12 Power Supply drawings
Posted by Tommie in Data General Minicomputer Projects, The Data General Nova 3 Restoration Project on Sunday 7 February, 2010
I have two Nova 3/12’s. One equipped with:
- NOVA 3 CPU, PWRFAIL, PRLOAD, 256KW
- NOVA 3 TRIPPLE OPT, MMPU, PAR, MUL/DIV, RTC
- 64KW Plessey, 128K SC, W PAR, 0-127
- DGC NOVA CASSETTE I/O, $TTI/O, 9600 B, RTC
- DISK CARTRIDGE CONTROL DGC NOVA, DKP, 4234, 6030
- DGC NOVA CASSETTE I/O, $TTI/O, 9600 B, RTC
The other is an empty chassis, both with faulty power supplies. I contacted Bruce Ray of Wild Hare Computer Systems and Bruce provided me with Nova 3/12 Power Supply and backplane drawings. I still have to troubleshoot and repair the power supplies, but at least I now have the drawings and the tools.
Just received some pictures of the S/280
Posted by Tommie in Data General Minicomputer Projects, The Data General Eclipse S/280 Restoration Project on Thursday 28 January, 2010
Today my contact at FMV sent some pictures of the S/280 and the disk he has in storage and that they will donate for free to me. The guy is extremely friendly and helpful and so is his boss. The world would be a much better place if people were like these guys and I owe them a big “thank you“! Will work out with FMV how to ship the equipment to me.
-
- Eclipse S/280 front view
-
- Eclipse S/280 side view
-
- S/280 Disk Drive
Brought the Nova 3 home to work on it
Posted by Tommie in Data General Minicomputer Projects, The Data General Nova 3 Restoration Project on Tuesday 17 November, 2009
I brought the Nova 3 home and put in on a workbench in the hallway with the intention of:
- stripping it to pieces
- clean the metal parts from dust and rust
- clean the plastic front panel
- clean the PCB’s from dust, dirt and oxide
- check the power suplly for correct voltages and ripple
- assemble the parts
- test cpu and memory
Found an Eclipse S/230
Posted by Tommie in Data General Minicomputer Projects on Friday 11 September, 2009
After a tip from a former Data General colleague, that there could be a Nova 3 available that he worked on and that was still being used in 1995, I started tracking the system. After several calls I ended up with a former customer of mine, the Swedish DoD. The guy did not know about the Nova 3 system, but suspected that it had been scrapped. However, he told me that they had an Eclipse S/230 that they still used but was going the replace the CPU with an MV/9500.
Created an inventory webpage with minicomputer parts
Posted by Tommie in Data General Minicomputer Projects on Thursday 27 August, 2009
In order to have a catalog I created a simple web page with my Data General minicomputer parts at http://www.foxdata.com/minicomputers/minicomputer_parts_list.htm. I’d be happy to trade or sell some of my parts.